Grass Valley 8964ENC v.1.2.2 - Manual (Page 42)

42 8964ENC/-FS — Instruction Manual
Configuration
Module Configuration Pages
Module configuration is provided for the following functions with the web
page GUI interface:
• SDI In ( page 43 )
• Timing ( page 44 )
• Picture Enhancer ( page 47 )
• VBI ( page 47 )
• Video Proc ( page 49 )
• Noise Reducer ( page 51 )
• Composite Out ( page 52 )
Read-only information about the module is given on the top of each web
page including model name and description, frame and slot location and
last E-MEM register recalled.
When a channel is selected to configure, the input name (as defined on the
I/O Config web page) will be displayed under the selected channel or will
show the default name. Each channel will show the signal reference type
(NTSC or PAL).
After making a parameter value change, click on Apply to activate settings
in each selection. Each of the four encoder channels can be adjusted sepa-
rately or settings can be applied to other or all channels. Use the
Apply Setting
To ( Channel 1, 2, 3 or 4 as applicable) or All buttons to apply the same values
to the other channels selected or all channels.
To reset the current channel or all channels to factory defaults, select the
Reset defaults for
Current Channel or All Channels buttons.
Select the Back , Functional View , or Next link to navigate to the next function or
use the links on the left of the web page.
Click on the Refresh button at the top of the display to update the entire dis-
play.