Grass Valley 8964ENC v.1.2.2 - Manual (Page 14)

14 8964ENC/-FS — Instruction Manual
Installation
Rear Module Installation
All unused rear slots in a GeckoFlex frame should have a blank rear
adapter cover installed.
1. Each 8900V-R rear module or blank rear adapter cover is held in place
by two retainer clips as shown in
Figure 3 . Loosen (but do not remove
completely) the two screws holding each retainer clip to the frame with
a 2 mm (5/64”) hex screwdriver or the Rear Retainer Clip tool provided
(751- frames only). Pull up on the retainer to remove it, leaving the
screws in place.
CAUTION Be careful to leave the screws in place as they can be easily lost or fall into
equipment below the frame creating a shorting hazard.
2. Remove the blank rear adapter cover by inserting needlenose pliers
into the slots in the top and bottom of the blank and pulling it off.
Note To remove a rear module already installed, follow the same steps. It is helpful
to first remove the front module so the rear can be pulled out more easily.
3. Insert the rear module into the empty slot.
4. Replace each retainer clip over the two screws on both sides of the
module and push down to seat the retainer.
5. Tighten the screws for each retainer clip just until they are snug. Do not
force or torque the screws too tightly.
Figure 3. Installing Rear Module
8444_23
r0
Use retainer clip or
needlenose pliers
to pull out blank after
removing retainer clips