beautypg.com

8964enc module onboard configuration settings – Grass Valley 8964ENC v.1.2.2 User Manual

Page 30

background image

30

8964ENC/-FS — Instruction Manual

Configuration

8964ENC Module Onboard Configuration Settings

Onboard configuration is done on a channel-by-channel basis, there is no
gang mode (apply settings to all channels). You may use an on-screen
display on the output of each channel to view the parameters being
adjusted.

Control of the OSD function must first be enabled locally by setting jumper
JP3 (

Figure 10

) to either disabled, pins 1-2, or enabled, OSD_EN (pins 2-3).

Once OSD control has been enabled with JP3, it can be turned on or off with
individual local channel controls (Bank 1/Position 1) or through the web
browser (refer to

OSD Control Web Page on page 57

).

To make a configuration setting:

1.

Select the channel to be adjusted by pressing pushbutton SW2 to toggle
to the Channel Select Mode (yellow CSM LED on). This allows using
the paddle switch to increment through the channel selections. The
currently selected channel is indicated by the state of the CM1 and CM0
LED. Refer to

Table 5 on page 28

for reading LED states.

2.

When the desired channel is active, use pushbutton SW2 to toggle back
to Parameter mode (CSM LED off).

3.

Rotate the Function switch to Bank 1 (2ND LED off) or Bank 2
(2ND LED on) or Bank 3 (2ND LED slow flash) and to the desired
function within that bank.

4.

Move the paddle switch to the up or down position and hold
momentarily to set the desired function (refer to

Table 6 on page 31

).

Note

Holding the paddle switch in the up or down position for more than a half
second will automatically accelerate through the value range for parameters
with 256 or more values. The full range can be accessed in about 10 seconds.

This manual is related to the following products: