Local onboard module configuration, Configuration switches and controls – Grass Valley 8964ENC v.1.2.2 User Manual
Page 27
8964ENC/-FS — Instruction Manual
27
Configuration
Local Onboard Module Configuration
The 8964ENC module can be configured locally using the rotary and
paddle switches. Several LEDs interact with the switches to indicate status
of the configuration process.
Configuration Switches and Controls
Each of the four encoder channels is adjusted separately. Selection of each
channel is done with the paddle switch while in Channel Select Mode as
explained below. Refer to
for the following descrip-
tions. Use the onboard configuration components as follows:
•
SW1 Function (rotary) switch — This switch accesses a desired function
for configuration (see
). The switch addresses three
banks of functions; each bank has 16 possible positions (0 through 9 and
A through F). Not all positions are used.
The next bank of functions is accessed each time the Function switch
makes a complete revolution past zero (or back through F): While in
Bank 1, a complete revolution past zero accesses Bank 2; while in Bank
2, a complete revolution past zero accesses Bank 3. The yellow 2ND
LED indicates which bank is currently being accessed.
Note
The Function switch should be kept in position 0 in any bank (parked) when
not in use to avoid any inadvertent change in configuration. Position 0 in each
bank is inactive.
•
2ND (second Function) yellow LED – when off, indicates that the rotary
switch is addressing the first bank of functions. When on, indicates that
the rotary switch is addressing the second bank of functions. When
flashing, indicates that rotary switch is addressing the third bank of
functions.
•
SW3 (paddle) switch – actuates or selects the desired setting or channel
selection for the selected function when the switch is held momentarily
in either the up or down position. Switch between Parameter and
Channel Select Mode with pushbutton SW2.
•
CSM (Channel Select Mode) yellow LED – when on, paddle switch is in
Channel Select Mode. Use the paddle switch to select channel 1, 2, 3, or
4. When off, paddle switch is in Parameter mode.
•
CM1 and CM0 yellow LEDs – indicate what channel is active for adjust-
ment. Refer to
•
SW2 (pushbutton) switch – press to toggle assignment of paddle switch
SW3 between Parameter mode (CSM LED off) and Channel Select
Mode (CSM LED on).
•
CONF (configuring) yellow LED – when on, indicates the module is
programming hardware.