Grass Valley 8964ENC v.1.2.2 - Manual (Page 40)

40 8964ENC/-FS — Instruction Manual
Configuration
I/O Config Web Page
Use
this
link
The I/O Config web page ( Figure 15 ) shows the rear input and output con-
nections to the module and allows you to name each input. Type the
desired input name (up to 11 characters) into the corresponding box. The
status of each input is indicated by the color of the display.
Note Outputs are not monitored in this application.
SNMP trap reporting of each channel input can be enabled or disabled by
selecting or deselecting the corresponding checkbox in the
Reporting
column. You may disable reporting for channels not being used if desired.
The
Reporting column is also used when an SNMP monitoring application
such as NetCentral is installed.
Refer to 8964ENC Fuse and Voltage Testpoint Locations on page 66 for an
explanation of the color coding and using an SNMP monitoring applica-
tion.
Figure 15. 8964ENC I/O Config Web Page