Grass Valley 8960ENC v.8.1.0 - Manual (Page 15)

8960ENC—Instruction Manual 15
Installation
Cabling
Cable the module as described below for either frame type.
Loop-through Input
Connect an input source to one of the loop-through input connectors, J9 or
J10 (see
Figure 6 ). The 8960ENC input will accept serial digital video con-
forming to SMPTE 259M 10-bit, 4:2:2 component digital standard. Termi-
nate the unused connector into 75 Ω if the signal is not looped to other
equipment.
Outputs
The 8960ENC has four analog NTSC/PAL outputs—J1 through J4. Connec-
tors J-5 and J-6 are reclocked SDI outputs.
Reference Inputs
Separate input BNCs are provided for either 625-line (J7) or 525-line (J8)
black burst reference signals. The reference inputs are 75 ohm or high
impedance (jumper selectable, see
Local Onboard Module Configuration on
page 22 ).
Figure 6. 8960 Input/Output Connectors
J2
J4
J6
J8
J1
J9 J10
IN
Four NTSC/PAL
Outputs J1 - J4
X
O
U
T
J3
J5
J7
J2
J4
J6
J8
0642_02r1
SDI Loop-through
Input
625 Reference
Input
525 Reference
Input
Reclocked SDI Output Reclocked SDI Output