Grass Valley 8960ENC v.8.1.0 - Manual (Page 10)

10 8960ENC—Instruction Manual
Installation
Installation
The 8960ENC can be installed in either an 8900 Gecko or an 8900FN
GeckoFlex frame. An 8900V-R rear module is required for use in the
GeckoFlex frame.
If using an 8900FSS Frame Sync submodule, mount it onto the 8960ENC
circuit board first below before installing the 8960ENC in the frame.
Frame Sync Submodule (8900FSS)
An optional Frame Sync submodule is available for providing frame syn-
chronization to an external reference. The submodule installs on the
8960ENC circuit board.
Installation
Install the submodule onto the main circuit board by lining up the two con-
nectors on the submodule with the connectors on the module. Make sure
the connectors are aligned properly then press to seat the submodule.
Insert and tighten the center screw to secure the submodule and assure that
the connectors are in proper alignment.
Termination
When used on the 8960ENC host module, the Frame Sync Submodule ref-
erence signal input termination should be set to high impedance (see
Figure 1 ).
Figure 1. Frame Sync Submodule Reference Signal Termination Selection
8900FSS
0642-08r1
Temination
jumpers in
high impedance
position
JP3 NTSC
Ref.
JP4 PAL
Ref.
75
75
HI IMP
HI IMP
Insert and tighten screw
to secure submodule.