H3C Technologies H3C SecPath F1000-E - Manual (Page 170)

24
[Device-GigabitEthernet1/2] ipv6 address 3001::1/64
[Device-GigabitEthernet1/2] quit
[Device] interface gigabitethernet 1/1
[Device-GigabitEthernet1/1] ip address 1.1.1.1 255.0.0.0
[Device-GigabitEthernet1/1] quit
# Configure an ISATAP tunnel.
[Device] interface tunnel 0
[Device-Tunnel0] ipv6 address 2001::5efe:0101:0101 64
[Device-Tunnel0] source gigabitethernet 1/1
[Device-Tunnel0] tunnel-protocol ipv6-ipv4 isatap
# Disable the RA suppression so that hosts can acquire information such as the address prefix from the
RA message released by the ISATAP device.
[Device-Tunnel0] undo ipv6 nd ra halt
[Device-Tunnel0] quit
# Configure a static route to the ISATAP host.
[Device] ipv6 route-static 2001:: 16 tunnel 0
• Configuration on the ISATAP host
The specific configuration on the ISATAP host is related to its operating system. The following example
shows the configuration of the host running the Windows XP.
# Install IPv6.
C:\>ipv6 install
# On a Windows XP-based host, the ISATAP interface is usually interface 2. Configure the IPv4 address
of the ISATAP device on interface 2 to complete the configuration on the host. Before that, display
information on the ISATAP interface:
C:\>ipv6 if 2
Interface 2: Automatic Tunneling Pseudo-Interface
Guid {48FCE3FC-EC30-E50E-F1A7-71172AEEE3AE}
does not use Neighbor Discovery
does not use Router Discovery
routing preference 1
EUI-64 embedded IPv4 address: 0.0.0.0
router link-layer address: 0.0.0.0
preferred link-local fe80::5efe:2.1.1.2, life infinite
link MTU 1280 (true link MTU 65515)
current hop limit 128
reachable time 42500ms (base 30000ms)
retransmission interval 1000ms
DAD transmits 0
default site prefix length 48
# A link-local address (fe80::5efe:2.1.1.2) in the ISATAP format was automatically generated for the
ISATAP interface. Configure the IPv4 address of the ISATAP device on the ISATAP interface.
C:\>ipv6 rlu 2 1.1.1.1
After carrying out the above command, look at the information on the ISATAP interface.
C:\>ipv6 if 2
Interface 2: Automatic Tunneling Pseudo-Interface
Guid {48FCE3FC-EC30-E50E-F1A7-71172AEEE3AE}