H3C Technologies H3C SecPath F1000-E - Manual (Page 162)

16
Tunnel0 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::C0A8:6401
Global unicast address(es):
::192.168.100.1, subnet is ::/96
Joined group address(es):
FF02::1:FFA8:6401
FF02::1:FF00:0
FF02::2
FF02::1
MTU is 1480 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
InReceives: 65
...
[DeviceB] display ipv6 interface tunnel 0 verbose
Tunnel0 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::C0A8:3201
Global unicast address(es):
::192.168.50.1, subnet is ::/96
Joined group address(es):
FF02::1:FFA8:3201
FF02::1:FF00:0
FF02::2
FF02::1
MTU is 1480 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
InReceives: 65
...
# Ping the IPv4-compatible IPv6 address at the peer end from Device A.
[DeviceA] ping ipv6 ::192.168.50.1
PING ::192.168.50.1 : 56 data bytes, press CTRL_C to break
Reply from ::192.168.50.1
bytes=56 Sequence=1 hop limit=64 time = 1 ms
Reply from ::192.168.50.1
bytes=56 Sequence=2 hop limit=64 time = 1 ms
Reply from ::192.168.50.1
bytes=56 Sequence=3 hop limit=64 time = 1 ms
Reply from ::192.168.50.1
bytes=56 Sequence=4 hop limit=64 time = 1 ms
Reply from ::192.168.50.1
bytes=56 Sequence=5 hop limit=64 time = 1 ms