H3C Technologies H3C SecPath F1000-E - Manual (Page 144)

3
To do… Use the command… Remarks
Enter system view system-view —
Use an ACL to control the device’s
access to TFTP servers tftp-server [ ipv6 ] acl
acl-number
Optional
By default, no ACL is used to
control the device’s access to TFTP
servers.
Configure the source address of
sent TFTP packets
tftp client source { interface
interface-type interface-number |
ip source-ip-address }
Optional
A device uses the source address
determined by the matched route
to communicate with the TFTP
server by default.
Return to user view quit —
Download or upload a file in an
IPv4 network
tftp server-address { get | put |
sget } source-filename
[ destination-filename ]
[ [ vpn-instance
vpn-instance-name ] | [ source
{ interface interface-type
interface-number | ip
source-ip-address } ] ]
Optional
Available in user view
Download or upload a file in an
IPv6 network
tftp ipv6 tftp-ipv6-server [ -i
interface-type interface-number ]
{ get | put } source-file
[ destination-file ]
Optional
Available in user view
NOTE:
•
If no primary IP address is configured on the source interface, no TFTP connection can be established.
• If you use the tftp client source command to configure a source interface and then use it to configure a
source IP address, the source IP address overwrites the source interface, and vice versa.
Displaying and Maintaining the TFTP Client
To do… Use the command… Remarks
Display the configuration of the
TFTP client display tftp client
configuration
Available in any view
TFTP Client Configuration Example
Network requirements
• As shown in Figure 5 , use a PC as the TFTP server and Device as the TFTP client. Their IP addresses
are 1.2.1.1/16 and 1.1.1.1/16 respectively. Device and PC are reachable to each other.
• Device downloads a startup file from PC for upgrading and uploads a configuration file named
config.cfg to PC for backup.