H3C Technologies H3C SecPath F1000-E - Manual (Page 158)

12
[DeviceB] ipv6
# Configure an IPv4 address for GigabitEthernet 1/2.
[DeviceB] interface gigabitethernet 1/2
[DeviceB-GigabitEthernet1/2] ip address 192.168.50.1 255.255.255.0
[DeviceB-GigabitEthernet1/2] quit
# Configure an IPv6 address for GigabitEthernet 1/1.
[DeviceB] interface gigabitethernet 1/1
[DeviceB-GigabitEthernet1/1] ipv6 address 3003::1 64
[DeviceB-GigabitEthernet1/1] quit
# Configure an IPv6 manual tunnel.
[DeviceB] interface tunnel 0
[DeviceB-Tunnel0] ipv6 address 3001::2/64
[DeviceB-Tunnel0] source gigabitethernet 1/2
[DeviceB-Tunnel0] destination 192.168.100.1
[DeviceB-Tunnel0] tunnel-protocol ipv6-ipv4
[DeviceB-Tunnel0] quit
# Configure a static route to IPv6 Group 1 through tunnel 0 on Device B.
[DeviceB] ipv6 route-static 3002:: 64 tunnel 0
Configuration verification
After the above configurations, display the status of the tunnel interfaces on Device A and Device B,
respectively.
[DeviceA] display ipv6 interface tunnel 0 verbose
Tunnel0 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::C0A8:6401
Global unicast address(es):
3001::1, subnet is 3001::/64
Joined group address(es):
FF02::1:FF00:0
FF02::1:FF00:1
FF02::1:FFA8:6401
FF02::2
FF02::1
MTU is 1480 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
InReceives: 55
...
[DeviceB] display ipv6 interface tunnel 0 verbose
Tunnel0 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::C0A8:3201
Global unicast address(es):
3001::2, subnet is 3001::/64