H3C Technologies H3C WX5000 Series Access Controllers User Manual
Page 56
5-16
Enter 3 on the BootWare main menu to enter the Ethernet submenu. Then, enter 5 on the submenu to
enter the Ethernet interface configuration interface:
============================
|Note: '.' = Clear field. |
| '-' = Go to previous field. |
| Ctrl+D = Quit. |
================================================================================
Protocol (FTP or TFTP) :tftp
Load File Name :host
:main.bin
Target File Name :target
:main.bin
Server IP Address :192.168.0.250
Server IP Address :192.168.0.1
Local IP Address :192.168.0.10
Gateway IP Address :0.0.0.0
z
When configuring a parameter, you can enter a new value directly, or press Enter to accept the
default value, which is after the colon. Type a dot (.) to clear the input, a hyphen (-) to return to the
previous parameter field, and a combination of ^D (namely, Ctrl+D) to exit the parameter
configuration interface.
z
The WX5002V2 supports only GigabitEthernet 1/0/1 for application upgrade.
Upgrading Applications Through an Ethernet Interface
The Trivial File Transfer Protocol (TFTP) is a TCP/IP protocol used for file transfer between client and
server. It provides a simple and low-cost file transfer service. TFTP provides unreliable data transfer
over UDP and does not provide any access authorization and authentication mechanism. It employs the
timeout retransmission method to implement best-effort delivery of data. Compared with FTP, TFTP has
a much smaller software size.
Follow these steps to upgrade an application file through the management Ethernet interface (10/100
Base-TX):
Step1
Set up a software upgrade environment.
Figure 5-7
Set up a software upgrade environment