H3C Technologies H3C WX5000 Series Access Controllers User Manual
Page 50
5-10
Then, press the Enter key, and the system will prompt the current baud rate.
The current baudrate is 115200 bps
==============================
|Note:'*'indicates the current baudrate |
| Change The HyperTerminal's Baudrate Accordingly |
|---------------------------
|<1> 9600(Default) |
|<2> 19200 |
|<3> 38400 |
|<4> 57600 |
|<5> 115200* |
|<0> Exit |
==========================================================================
Enter your choice(0-5):
After downloading files with a changed baud rate, timely change the baud rate back to 9,600 bps in
HyperTerminal to ensure the normal display on the console screen when the system boots or reboots.
Upgrading the BootWare Through an Ethernet Interface
Enter the BootWare main menu (refer to section “
” on page
). On the BootWare
main menu, enter 7. The system will enter the BootWare operation submenu, where you can perform all
BootWare operations. For details about this menu, refer to section “
page
.
Enter 4 on the BootWare operation submenu to enter the BootWare operation Ethernet submenu:
=====================
|<1> Update Full BootWare |
|<2> Update Extend BootWare |
|<3> Update Basic BootWare |
|<4> Modify Ethernet Parameter |
|<0> Exit To Main Menu |
================================================================================
Enter your choice(0-4):
Enter 4 on the BootWare operation Ethernet submenu. The system prompts you to modify the network
parameters.
============================
|Note: '.' = Clear field. |
| '-' = Go to previous field. |
| Ctrl+D = Quit. |
================================================================================
Protocol (FTP or TFTP) :tftp