Upgrading the bootware through a serial interface – H3C Technologies H3C WX5000 Series Access Controllers User Manual
Page 52
5-12
|Note:the operating device is cfa0 |
|<1> Backup Full BootWare |
|<2> Restore Full BootWare |
|<3> Update BootWare By Serial |
|<4> Update BootWare By Ethernet |
|<0> Exit To Main Menu |
===========================================================================
Enter your choice(0-4):
Enter 0 on the BootWare operation submenu to return to the BootWare main menu:
===========================
|<1> Boot System |
|<2> Enter Serial SubMenu |
|<3> Enter Ethernet SubMenu |
|<4> File Control |
|<5> Modify BootWare Password |
|<6> Skip Current System Configuration |
|<7> BootWare Operation Menu |
|<8> Clear Super Password |
|<9> Storage Device Operation |
|<0> Reboot |
============================================================================
Enter your choice(0-9): 0
Enter 0 on the BootWare main menu to reboot the access controller.
Upgrading the BootWare Through a Serial Interface
Enter the BootWare main menu (refer to section “
” on page
). On the BootWare
main menu, enter 7. The system will enter the BootWare operation submenu, where you can perform all
BootWare operations. For detail description on this submenu, refer to section “
” on page
.
Enter 3 on the BootWare operation submenu to enter the BootWare operation serial submenu:
======================
|<1> Update Full BootWare |
|<2> Update Extend BootWare |
|<3> Update Basic BootWare |
|<4> Modify Serial Interface Parameter |
|<0> Exit To Main Menu |
================================================================================
Enter your choice(0-4):
Enter 4 on the BootWare operation serial submenu. The system prompts you to modify the baud rate:
=================================
|Note:'*'indicates the current baudrate |
| Change The HyperTerminal's Baudrate Accordingly |
|-----------------------------
|<1> 9600(Default)* |
|<2> 19200 |
|<3> 38400 |