H3C Technologies H3C WX5000 Series Access Controllers - Manual (Page 39)

4-4
Powering on the Access Controller
After the access controller is powered on, the system first initializes memory. After the initiation, the
system runs the extended BootWare, and the following information is displayed on the terminal:
System is starting...
Booting Normal Extend BootWare....
The Extend BootWare is self-decompressing..................
Done!
**************************************************************************
* *
* H3C WX5002 BootWare, Version 1.06 *
* *
**************************************************************************
Copyright (c) 2004-2009 Hangzhou H3C Technologies Co., Ltd.
Compiled Date : Nov 9 2009
CPU Type : XLR716
CPU L1 Cache : 32KB
CPU Clock Speed : 800MHz
Memory Type : DDR2 SDRAM
Memory Size : 2048MB
Memory Speed : 533MHz
BootWare Size : 512KB
Flash Size : 4MB
cfa0 Size : 259MB
CPLD Version : 008
PCB Version : Ver.A
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
Press Ctrl+B to enter the extended boot menu; otherwise, the system will start loading and
decompressing the application file.
z
You must press Ctrl+B in four seconds when “Press Ctrl+B to enter extended boot menu” appears.
Otherwise, the system will not enter the extended boot menu but start loading and decompressing
the application file.
z
You need to reboot the access controller if you want to enter the extended boot menu after the
application file is decompressed.
z
The extended BootWare menu is referred to as the BootWare main menu in this manual unless
otherwise specified.