H3C Technologies H3C WX5000 Series Access Controllers - Manual (Page 38)

4-3
Figure 4-4 HyperTerminal window
Step6 Set HyperTerminal properties. Select File > Properties > Settings in the HyperTerminal to enter the
properties setting window, as shown in
Figure 4-5 . Select VT100 as the terminal emulation, and click
OK .
Figure 4-5 Set terminal emulation
Powering On the Access Controller
Checking Before Power-On
Before powering on the access controller, verify that:
z
The power cord and the ground wire are properly connected.
z
The power supply voltage is within the range that required by the access controller.
z
The console cable is properly connected; the terminal (for example, a PC) used for configuration
has been started; the configuration parameters have been set.