H3C Technologies H3C WX5000 Series Access Controllers - Manual (Page 37)

4-2
Figure 4-2 Select the serial interface used for HyperTerminal connection
Step4 Click OK and the system displays the following interface, as shown in Figure 4-3 . On the interface, set
Bits per second to 9600, Data bits to 8, Parity to None, Stop bits to 1, and Flow control to None.
Figure 4-3 Set serial port parameters
To use the default settings, click Restore Defaults.
Step5 Click OK and the system displays the HyperTerminal interface.