H3C Technologies H3C S3600V2 Series Switches - Manual (Page 53)

47
Transceiver module
Central
wavelength
Connector Fiber
Max
transmission
distance
62.5/125 μm,
multimode 275 m
(902.23 ft)
SFP-GE-LX-SM1310-A
10 km (6.21
miles)
SFP-GE-LH40-SM1310
1310 nm
40 km (24.86
miles)
SFP-GE-LH40-SM1550
40 km (24.86
miles)
SFP-GE-LH70-SM1550
1550 nm
9/125 μm, single
mode
70 km (43.50
miles)
SFP-GE-LX-S
M1310-BI
DI
TX: 1310 nm
RX: 1490 nm
SFP-GE-LX-S
M1490-BI
DI
You must
use these
two
transceiver
models in
pairs.
TX: 1490 nm
RX: 1310 nm
9/125 μm, single
mode 10 km (6.21
miles)
SFP-STACK-Kit N/A N/A UTP/STP
1.5 m (4.92
ft.)
SFP-GE-T N/A RJ-45 UTP/STP
100 m
(328.08 ft.)
NOTE:
•
To guarantee the functionality of the SFP ports, always use H3C SFP transceiver modules on the H3C
S3600V2 Switch Series.
• The SFP transceiver modules available for this switch series are subject to change over time. For the most
up-to-date list of SFP transceiver modules, consult your H3C sales representative or technical support
engineer.
• For the SFP transceiver module specifications, see the H3C Low End Series Ethernet Switches Pluggable
Modules Manual.
• For how to install or remove an SFP module, see the H3C Pluggable SFP/SFP+/XFP Transceiver
Modules Installation Guide.
Combo interface
A combo interface has one fiber SFP port and one 1000Base-T copper Ethernet port. These two ports
share one port number and cannot work simultaneously. When you activate one port, the other port
automatically shuts down.
On the front panel of an S3600V2 switch, the copper combo ports are marked in the port number + T
format, and the fiber SFP combo ports are marked in the port number + S format.
Figure 42 uses the
S3600V2-52TP-SI front panel as an example.