H3C Technologies H3C S3600V2 Series Switches - Manual (Page 24)

18
Connecting the power cord
CAUTION:
Before powering on the switch, you must connect the power cord and make sure the switch is well
grounded.
Connecting an AC power cord
Follow these steps to connect an AC power cord:
Step1 Wear an ESD-preventive wrist strap, and make sure the wrist strap makes good skin contact and is well
grounded.
Step2 Install the bail latch. Fix the bail latch into the holes located at the two sides of the AC power receptacle.
Then pull the bail latch upwards, as shown in
Figure 26 .
Step3 Insert the plug of the AC power cord into the AC power receptacle (see callout 1 in Figure 27 ).
Step4 Pull the bail latch down to secure the plug to the AC receptacle (see callout 2 in Figure 27 ).
Step5 Connect the other end of the AC power cord to the AC power source.
Step6 Check the power LED (PWR) on the front panel. If the LED is on, the power cord is properly connected.
Figure 26 Connect the AC power cord (I)
Figure 27 Connect the AC power cord (II)
2
1
Connecting a DC power cord