H3C Technologies H3C S3600V2 Series Switches - Manual (Page 19)

13
Rack-mounting an S3600V2 switch
Step1 Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well grounded.
Step2 Check that the mounting brackets have been securely fixed on the two sides of the switch.
Step3 Install the user-supplied cage nuts in the mounting holes in the rack posts.
Step4 One person holds the switch chassis and aligns the mounting brackets with the mounting holes in the
rack posts, and the other person fixes the mounting brackets with anti-rust screws (user-supplied) to the
rack.
Step5 Check that the switch chassis is horizontal and tighten the screws.
Figure 19 Install the switch in the rack
Mounting the switch on a workbench
If a standard 19-inch rack is not available, you can place an S3600V2 switch on a clean, flat workbench,
as follows:
Step1 Check that the workbench is sturdy and well grounded.
Step2 Place the switch with bottom up, and clean the round holes in the chassis bottom with dry cloth.