H3C Technologies H3C S3600V2 Series Switches - Manual (Page 52)

46
Item Specification
Interface attributes
• 1000Mbps, full duplex
• MDI/MDI-X, auto-sensing
Max transmission
distance
100 m (328.1 ft)
Transmission medium Category-5 (or above) twisted pair cable
Standards IEEE 802.3u
100Base-X SFP port
The S3600V2-28F-EI switch provides 24 100Base-X SFP ports, and you can install the 100 Mbps SFP
transceiver modules in
Table 13 in the ports.
Table 13 100Base-X SFP transceiver modules available for the H3C S3600V2 Switch Series
Transceiver module
Central
wavelength
Connector Fiber
Max
transmission
distance
SFP-FE-SX-MM1310-A
62.5/125 μm,
multimode 2 km (1.24
miles)
SFP-FE-LX-SM1310-A
15 km (9.32
miles)
SFP-FE-LH40-SM1310
1310 nm
40 km (24.86
miles)
SFP-FE-LH80-SM1550 1550 nm
9/125 μm, single
mode
80 km (49.71
miles)
SFP-FE-LX-S
M1310-BI
DI
TX: 1310 nm
RX: 1550 nm
SFP-FE-LX-S
M1550-BI
DI
You must
use these
two
transceiver
modules in
pairs.
TX: 1550nm
RX: 1310 nm
LC
9/125 μm, single
mode 15 km (9.32
miles)
1000Base-X SFP port
Every S3600V2 switch has four 1000Base-X SFP ports, including two combo ports paired with two
1000Base-T Ethernet ports, on the front panel.
Table 14 lists the 1000Base-X SFP transceiver modules
available for the H3C S3600V2 Switch Series.
Table 14 1000Base-X SFP transceiver modules available for the H3C S3600V2 Switch Series
Transceiver module
Central
wavelength
Connector Fiber
Max
transmission
distance
SFP-GE-SX-MM850-A 850 nm LC
50/125 μm,
multimode 550 m
(1804.46 ft)