H3C Technologies H3C S5120 Series Switches - Manual (Page 64)

56
NOTE:
•
Enter the file name and IP addresses based on the actual condition.
• If the switch and the server are on the same network segment, specify any unused IP address of the
network for the switch without specifying the gateway’s IP address; if they are not on the same segment,
specify the gateway’s IP address so that the switch can communicate with the server.
6. Upgrade the Boot ROM file on the switch
Enter the corresponding parameters based on the actual condition. The system displays the following
information:
Loading........................................................................
...............................................................................
................................Done!
Will you Update Basic BootRom? (Y/N):Y
The system asks you whether you want to upgrade the basic Boot ROM section. Click Y. Then the system
displays the following information after the upgrade is complete:
Updating Basic BootRom...........Done!
Updating extended BootRom? (Y/N):Y
The system asks you whether you want to upgrade the extended Boot ROM section. Click Y. Then the
system displays the following information after the upgrade is complete:
Updating extended BootRom.........Done!
7. Restart the switch to make the upgraded Boot ROM file effective
Press any key to return to the Boot ROM upgrade menu.
Press enter key when ready
1. Update full BootRom
2. Update extended BootRom
3. Update basic BootRom
0. Return to boot menu
Enter your choice(0-3):
Enter 0 to return to the Boot ROM menu, and then enter 0 again. After that, the device is restarted and
the upgraded Boot ROM file becomes effective.
Loading a boot file
To load a boot file of the switch, enter 1 in the Boot ROM menu. The system displays the following
information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
You can enter 1 to load the boot file.
The procedure of loading a boot file is similar to that of loading a Boot ROM file except that the system
displays the prompt of loading the boot file rather than the Boot ROM file.
After loading the boot file, the switch displays that you should configure the application attribute, that is,
main, backup, or none. Type a specific attribute to complete loading the boot file.
Writing flash..................................................................