H3C Technologies H3C S5120 Series Switches - Manual (Page 35)

27
Figure 32 Hole distance
Xmm
NOTE:
•
The distance X between holes varies with devices. For specific distances, see Table 15 .
• Drill two holes according to the sizes of anchor kits and screws so that anchor kits could go into the
holes, only the edges could remain outside the wall, and the screws could be fixed on the wall tightly.
Step2 Insert anchor kits into the holes and keep only the edges outside the wall, as shown in Figure 33 .
Step3 Drive screws into the anchor kits, keeping the inside of screw head at least 1.5 mm (0.06 in) away from
the edge of the anchor kit so that the switch could hang on the screws securely.
Figure 33 Install the expansion screws
NOTE:
When you drive the screw to the anchor kit, the front end of the anchor kit expands to press against the
hole so that the screw can be fixed on the wall.
Step4 Align the two installation holes at the bottom of the switch with these two screws to hang the switch, as
shown in
Figure 34 .