H3C Technologies H3C S5120 Series Switches - Manual (Page 57)

49
Item Description
2. Set FTP protocol parameter Set FTP parameters
3. Set XMODEM protocol parameter Set XMODEM parameters
0. Return to boot menu Return to the Boot ROM menu
3. Configure the switch to download files by using XMODEM
Enter 3 to enter the download rate setting menu.
Please select your download baudrate:
1.* 9600
2. 19200
3. 38400
4. 57600
5. 115200
0. Return to boot menu
Enter your choice(0-5):
4. Set the download rate of the console port on the switch
Select an appropriate download rate. For example, if you select 115200 bps, that is, enter 5, the
following information is displayed:
Download baudrate is 115200 bps
Please change the terminal's baudrate to 115200 bps and select XMODEM protocol
Press enter key when ready
Now that the console communication baud rate of the switch has been changed to 115200 bps while
that of the terminal is still 9600 bps, the two sides cannot communicate with each other. According to the
prompt, you need to change the baud rate of the terminal to 115200 bps.
NOTE:
•
Typically, the size of a .bin file is over 9 MB. Even at a baud rate of 115200 bps, the update takes tens
of minutes.
• If you select 9600 bps as the download rate, you can skip the step Change the rate of the serial port
on the terminal .
5. Change the rate of the serial port on the terminal
To ensure communication between the terminal and the switch, the baud rate of the serial port on the
terminal should be consistent with that of the console port on the switch.
Step1 Select Call > Disconnect in the HyperTerminal window to disconnect the terminal from the switch.
Figure 52 Disconnect the terminal from the switch