Airaid 450-974 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
5. Install the Silicone Reducer and Hose
clamps onto the Carbon Fiber Airaid Intake
Tube. Place the small clamp on the Throttle
body side of the reducer, and the Large
clamp on to the tube side.
4. Transfer the 5/8” Grommet and the
5/8 Aluminum Fitting into the the Car-
bon Tube as shown. If installing onto
an Automatic transmission equipped ve-
hicle, you will need to drill a second hole
in the tube for the aspirator fitting and
Grommet.
6. Install The New Airaid Intake Tube in-
to the Hump Hose first, and then into the
Reducing Coupler. Adjust for fit, and
tighten all four hose clamps. Re connect
the Mass Airflow Sensor.
Reconnect the negative battery cable.
REV.12.5.13
A Note Regarding Custom Tuning
This intake system is not calibrated to any ECU program and is not to be used without being custom tuned.
Off the shelf aftermarket REPROGRAMERS (Superchips, Hypertech etc.) DO NOT constitute “custom tuning” .
Custom tuning is vehicle specific tuning, for that vehicle, and unique to its modifications. In other words it is ONE OFF programming. Since this tuning is unique to each
vehicle, AIRAID can not offer any assistance regarding any Tuning issues .
Failure to properly tune after installation of this system will result in poor performance and possible engine damage.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.