Airaid 250-992C - Manual (Page 2)

Instructions Revision
11-22-13
5. Install the Airaid Tube assembly onto the throttle body
and lower it downward towards the Mass Air Flow meter.
Slide the coupler all the way down onto the MAF and
secure the Intake grommets onto the posts on the radiator
shroud.
3. Transfer the factory intake tube mounting grommets
into the Tube Brackets as shown.
4. Slide the Hump Hose and #64 clamps onto the throttle
body side of the Intake Tube and the Coupler and #56
Clamps onto the air meter side. Leave all clamps loose at
this time.
Air meter side
6. Check the alignment of all the intake components and
adjust if necessary. Begin tightening the clamps from the
front of the intake and move back towards the throttle
body. Reconnect the battery.
Air meter side
Throttle body side