Airaid 883-315 - Manual (Page 3)

25. Carefully insert the Airaid Foam Prefilter (#6) into
the Snorkel Inlet. 26. Install the Snorkel Screen (#14) onto the Inlet using
the four 8-32 Button Head Screws(#29). 27. Attach the Snorkel Tube to the Loop Clamps using
three1/4-20 x 1 1/4 Bolts (#27), 1/4-20 Locknuts (#28),
and Flat washers (#21). Leave all hardware finger tight at
this time to allow for proper alignment
28. Close up of proper Snorkel hardware orientation. 29. Remove the Urethane Cap from the Airaid perfor-
mance Airbox if it has previously been installed. The
Clamp will be reused in step 34. 30. Install Cut out the fender Template and tape it in posi-
tion on the corner of the passenger side hood as shown.
34. Install the Flexible Duct onto the Airaid performance
airbox as shown using a # 48 Clamp. 35. Install the other end of the Ducting onto the Snorkel
tube using the last #48 Hose Clamp (#18). 36. Full view of Duct routing.
32. Install Slide the Speed Nuts (#25) onto the Cowl
plastic with the threaded side out. 31. Using a jig saw or equivalent, follow the template
and cut out the Duct relief. 33. Using a pair of dykes, pull out approximately three
windings of the steel wire inside of the Ducting (#16) and
cut it off.
37. Mount the duct to the Speed Nuts on the bulkhead
using the two 3” Loop Clamps (#26) and 1/4-20 x 1/2’
button Head Bolts (#20).
38. Slide the 10” Edge Trim (#25) over the cut out on
the Hood.
39. Align the Snorkel and Ducting and verify the
opening and closing action of the hood is not adversely
effected. Tighten all of the Clamp bolts when done.
Page 3