Airaid 883-305 - Manual (Page 2)

11. Drill out the bolt holes starting with a 1/8 pilot
hole and finishing with a 5/16” bit.
12. Trace the center oval onto the masking tape with a
marker.
9. Place a shop towel inside of the factory inlet hose to
prevent debris from entering.
13. Using a Dremel type rotary tool and a 1/8’ drill bit,
plunge into the inner oval at medium speed and cut
along the line until the center falls out. Remove the
tape.
15. Remove the shop towel and insert the Fender
Adapter into the fender hole and connect it to the fac-
tory air inlet. Do not tighten the hose clamp at this
time. 16. Mount the Adapter to the fender using Four 1/4-20
Button Head Bolts (#11), eight 1/4”Flat Washers (#13),
and four 1/4-20 Locknuts (#12). Tighten the factory air
inlet hose clamp. 17. To accommodate many cage variations, this kit is
supplied with an oversized Tube to Adapter coupler
(#6). Determine the required trim lengths for your
particular application and mark the coupler with a
permanent marker.
18. Once you have your coupler length marked, slide a
hose clamp (#9) onto the coupler and tighten the clamp
along the mark. Use the hose clamp as a guide to trim
the coupler to length with a sharp utility knife. 19. Install the trimmed Coupler with clamps (#9) onto
the Snorkel tube and the Fender adapter. Tighten the
Hose clamps and the three Snorkel Tube Clamps on the
cage.
10. Prepare the right front fender for cutting by cover-
ing the entire area with masking tape. Cut out the Tem-
plate and align all four edges against the radius of the
fender. Tape down the template and mark the bolt holes
with a center punch.
20. Tilt the bed back and install the Airaid Premium
filter (#1).
21. Reconnect the battery or batteries.
22.
Double check your work!
Make sure there is no foreign material in the intake
path. Make sure all clamps, hoses, bolts, and
screws are tight.
Make sure all clamps, hoses, bolts, and screws are
tight. Periodically check the tightness of all
hose
clamps.
14. Prepare the fender Adapter (#5) for installation by
wiping the mating surface down with a prep-sol or brake
clean and attaching the weatherstrip (#8). As shown.
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
REV.02.13.14
For your Oiled media filter we suggest using
the AIRAID Filter Tune-Up Kit!