Airaid 883-306 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
13. Mark the hole locations in each corner using a center
punch.
10. Install the Silicone Coupler (#8) and Two #48 Hose
Clamps (#10) onto the factory intake tube. Leave the
Clamps loose for now.
11. Insert the Airbox outlet into the Silicone coupler and
tighten the Clamps. Mount the airbox to the vehicle by
reusing the factory hardware from step one.
STOP ! If you have purchased the Snorkel kit PN
883-311 do not proceed to step 12. Refer to 883-311
instructions to complete installation.
12. Cut out the Template and carefully position it onto
the vehicles hood. Tape the template in place.
18
.
Place the Filter Tray (#4) onto the Air Box as
shown.
REV.02.07.14
14. Using a 1/8” bit , drill out the punched holes on the
hood. Finish the holes using a 1/2” bit or UniBit.
15. Using a jig saw, cut out the center section of the
hood.
16. Install the Edge Trim (#16) onto the hood, trim to fit. 17. Install the Urethane Cap (#9) onto the Airbox Inlet
tube and secure it using the third #48 Clamp.
19. Install the Hood Scoop onto the Airbox Assembly
using the four sets of 1/4-20 x 1/2’ Button Head Bolts
(#12) and 1/4” Flat Washers (#13). Leave the bolts loose
for now to allow for final adjustment.
21. Lower the hood down onto the vehicle and secure
it. Align the Hood Scoop from left to right inside of the
cut out . Raise the hood, secure the Bolts and re con-
nect the battery.
20. Insert the Foam Pre Filter (#6) into the Hood Scoop.
For your Oiled media filter we suggest
using the AIRAID Filter Tune-Up Kit!