Airaid 510-302 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
13. Place the engine cover back on top of the motor and
note the location where it comes in contact with the
Airaid Intake Tube. Remove the cover and trim the edge
approximately 1/8” and reinstall.
10. Slide the Hump Hose (#6), and two #68 Hose
Clamps (#21), onto the Intake Tube as shown. Slide the
Reducing Coupler (#7) and the #48 (#19) and #64
Clamps (#20) on the other end of the Intake Tube. Leave
the Clamps loose for now.
11. Install the Airaid Intake Tube onto the Cold Air Box
and the throttle body, align and tighten all four of the
Clamps. Reconnect the Mass Air Flow sensor.
12. Connect the factory crank case breather line to the
3/8 Barbed Fitting on the Intake Tube and replace the
OEM vacuum line on the fuel pressure regulator with the
supplied 17” 1/8” line. Connect the 1/8” line to the sec-
ond Fitting on the Intake tube.
Pre Filter Option-
Part Number
799-445
For maximum protection in the harshest of environ-
ments Airaid offers a slip on Pre Filter.
- Prolongs Cleaning Intervals
- Water Repellant
- Free Flowing Protection
REV.12.08.14
14. Install the Airaid Premium Filter (#1) onto the Filter
Adapter.
15. Place the Gasket (#8) onto the underside of the Air
Box Lid (#4) and peel off the protective film. Mount the
lid on the Air Box using four 1/4-20 x 1/2” Button Head
Bolts (#16), and 1/4” Flat washers (#17).
16.
Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses, bolts,
and screws are tight. Double check the hood
clearance!
Reconnect the negative battery cable!
Hump Hose
Reducer
9. Install the 1/8”and 3/8” barbed fittings (#s 11 and 12)
into the Airaid Intake Tube as shown.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
FILTER IDENTIFICATION
700-462 Airaid Oiled Media 701-462 Airaid SynthaMax Dry Media - Red
702-462 Airaid SynthaMax Dry Media - Black 703-462 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning with
common non-petroleum all-purpose house-
hold cleaner and water. Simple Green®,
Formula 409® or equivalent works great.
Apply cleaner to outside of air filter and al-
low to soak. Then flush filter clean from the
inside out with a garden hose and repeat
steps if necessary. Do not apply high pres-
sure water or air to clean filter. Allow filter
to air dry and reinstall
.