Airaid 510-301 - Manual

Installation Instructions
For Part Numbers:
510-301 700-462 Airaid Oiled Media Filter
511-301 701-462 SynthaMax Dry Media Filter - Red
512-301 702-462 SynthaMax Dry Media Filter - Black
513-301 703-462 SynthaMax Dry Media Filter - Blue
2005-11 Toyota Tacoma
2007-09 Toyota FJ Cruiser
4.0L V6
3. A.) Disconnect the Mass Air Flow meter .
B.) Pr y the wir e har ness anchor out of the air box.
C.) Disconnect the cr ankcase br eather line.
2. Loosen the clamp on the factory intake tube and
remove the two 8mm bolts securing the other end on
the inner fender. Slide the intake tube out from the in-
ner fender hole and set it aside.
4. Remove the factory airbox
Loosen the clamp on the throttle body side of the factory
airbox and remove the two 6mm bolts securing it to the
motor. Remove the entire airbox assembly from the ve-
hicle. 5. Install two of the M8 CAB Mounts (#13), hand tight,
into the weld nuts on the inner fender as shown. Use
the third CAB Mount to replace the 8mm bolt holding
the A/C bracket. 6. Apply the self adhesive, Foam Weatherstrip (#9) onto
the air inlet on the Cold Air Box (#3).
8. Transfer the Mass Air Flow sensor from the factory
airbox, into the Airaid Intake tube and secure using the
two #8 Spacers (#18) and 8-32 Socket Head screws
(#22) . Do not use the factory screws. 7. Mount the Filter Adapter (#5) to the Cold Air Box, as
shown, using three 1/4-20 x 1/2” Button head Bolts
(#16) and 1/4” Flat Washers (#17).
A.
Component Identification
1. Airaid Premium Filter 1
2. Airaid Intake Tube 1
3. Cold Air Box 1
4. Air Box Lid 1
5. Filter Adapter 1
6. Hump Hose 1
7. Reducing Coupler 1
8. Airbox Gasket 1
9. Foam Weather Strip 1
10. 1/8 x 20 1/2” Vacuum Line 1
11. 1/8 NPT Barbed Fitting 1
12. 3/8 NPT Barbed Elbow 1
13. M8 CAB Mount 3
14. 8 mm x 1.25 x 16 Bolt 3
15. 5/16 Flat Washer 3
16. 1/4-20 x 1/2 Button Head Bolt 7
17. 1/4 Flat Washer 7
18. #8 spacer 2
19. #48 Hose Clamp 1
20. #64 Hose Clamp 1
21. #68 Hose Clamp 2
22. 8-32 Socket Head Screw 2
Note: This intake system is not compatible with the
factory engine cover.
Disconnect The Negative Battery Terminal.
1. Using a 10mm Socket, remove the two acorn nuts on
the top of the motor and remove the engine cover.
C.
B.
SPACER
7. Mount the Cold Air Box onto the CAB Mounts us-
ing the three 8mm Bolts (#14) and 5/16 Flat Washers
(#15).
Bracket
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.