Filter identification – Airaid 510-179 User Manual
Page 2
11. Install the urethane hump hose (#4), and
two #72 hose clamps (#8) on the tube of the
CAD as close to the panel as possible. Leave
the hose clamps loose for now.
12. Install the CAD into the vehicle by aligning
the hump hose with the tube on the factory air-
box, and then aligning the two holes in the bot-
tom of the CAD with the two mounting holes on
the inner fender. Install the two supplied 8mm
bolts (#14) and washers (#15).
13. Install the supplied 6mm bolt (#12) and
washer (#13) thru the tab on the CAD and into
the threaded hole in the side of the fender.
14. Center the hump hose between the tube on
the factory airbox, and the tube on the CAD,
adjust for fit, and tighten the hose clamps.
15. Install the Airaid Premium Filter (#1) on the
CAD tube and tighten the clamp. Next install the
weather strip (#7) on top of the CAD as shown.
For an easier install, start at the fender side of the
CAD and work your way towards the radiator.
16. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses, bolts,
and screws are tight. Periodically check the
tightness of all hose clamps. Double check the
hood clearance.
17. Reconnect the negative battery
cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.10.28.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris, care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is
reusable and should be cleaned periodically.
10. Assemble the Cool Air Dam panels (#2), and
(#3) using the six supplied screws (#9), washers
(#10), and nuts (#11), as shown.
FILTER IDENTIFICATION
700-458 Airaid Oiled Media 701-458 Airaid SynthaMax Dry Media - Red
702-458 Airaid SynthaMax Dry Media - Black 703-458 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.