Filter identification – Airaid 510-134 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
13. Connect factory 3/8” vacuum line to nylon fitting
on intake tube & connect steel tube on intake mani-
fold to ¼” fitting on intake tube with ¼” vacuum
line provided.
10. Position the Airaid intake assembly in place of the
original, factory assembly. Using three supplied
8mm bolts and washers, mount the Airaid assem-
bly using the three original/factory mounting
points.
11. Connect the Airaid intake tube to the engine by slid-
ing the coupler over the throttle body & adjust the
intake tube to insure proper alignment from the
throttle body to the air filter adapter. (Note: Leave
a gap between the tube and the air filter adapter to
allow for engine movement)
12. Reinstall the electrical connector to the Mass Air
Sensor.
REV.10.25.13
14. Using the supplied 5/8” to ½” barbed connector and
½” x 4” breather hose, connect the factory hose
located by the throttle body to the Airaid intake
tube. Use two supplied #16 Speed clamps to secure
the hose to the barbed ends.
15. Mount the Airaid premium air filter inside the
Cool Air Dam & press weather strip onto the top
of the Cool Air Dam. (Hint: start at a corner and
work towards the ends)
FILTER IDENTIFICATION
700-451 Airaid Oiled Media 701-451 Airaid SynthaMax Dry Media - Red
702-451 Airaid SynthaMax Dry Media - Black 703-451 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require
oil. Service air filter as needed by
cleaning
with
common
non-
petroleum all-purpose household
cleaner and water. Simple Green®,
Formula 409® or equivalent works
great. Apply cleaner to outside of air
filter and allow to soak. Then flush
filter clean from the inside out with a
garden hose and repeat steps if nec-
essary. Do not apply high pressure
water or air to clean filter. Allow fil-
ter to air dry and reinstall.
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
16. Double check your work to be certain that all
nuts, bolts, and clamps are securely fastened.
17. Reconnect the negative battery cable.
Secure air dam with
three bolts
Front of vehicle