Airaid 450-329 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
14. Slide the Hump Hose with 2, #68 Clamps onto the
Filter Adapter and the Reducer with one, #64 and one
#56 clamp onto the throttle body as shown.
12. Install the Panel assembly into the engine compart-
ment as shown and secure using the OEM hardware
removed in steps
5 and 11.
13. When properly installed, the Panel tab resides be-
hind the fan shroud as shown.
15. Transfer the Mass Airflow sensor into the Airaid
Intake Tube as shown and secure it using the #8 Button
Head Screws. Do Not Use the OEM hardware.
16. Insert a 1/2” Grommet and Fitting into the Intake
Tube as shown.
For your Oiled media filter we suggest using
the AIRAID Filter Tune-Up Kit!
17. Insert the remaining 1/2” and 13/16”Grommets with
Aluminum Fittings into the Airaid Intake tube as shown.
Install the resonator Cap and secure it using the Speed
clamp.
18. Insert the supplied Firewall Plug to prevent debris
from entering the cabin as shown.
19. Insert the Intake Tube into the Hump Hose and
Reducer then tighten all 4 Intake Clamps. Reconnect
the factory breather lines.
21. Install the Airaid Premium Filter onto the Filter
Adapter. Install the weatherstrip on top of the Panel
assembly as shown with the contour rolling away from
the filter.
20. Split one edge of the remaining Grommet with a
sharp knife and run the MAF harness through it. Install
the Grommet and harness into the Panel Assembly as
shown. Reconnect the sensor.
11. Remove the drivers side, upper fan shroud bolt and
set it aside.
22. Double check your work. Make sure all clamps,
hoses, bolts, and screws are tight. Double check the
hood clearance. Reconnect the negative battery cable
and reinstall the cover and strut brace, if so equipped.
REV01.13.15
Airaid Screws
Fitting
Grommet
Grommets
Fittings
Cap
Cut
#64
#68
#56
10. Transfer the OEM air box grommet and anti-crush
sleeve into the Panel assembly as shown.