Airaid 450-326 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
13. Place the Airaid Airbox assembly into the engine
compartment.as shown with the locator pin on the bot-
tom of the box inside the fender grommet. Secure the
airbox by reusing the 6mm bolt removed in step # 3.
11. Insert the air temperature sensor into the Airaid intake
tube as shown and secure it suing the #8 Screw and
Washer.
12. Install the Filter Adapter onto the Cold Air Box as
shown using the three 1/4-20 Button Head Screws and
1/4” Flat Washers.
14. Slide the Hump Hose and Clamps onto the Filter
Adapter as shown. Do not tighten the clamps at this time.
15. Lower the Airaid Intake tube down into position
and slide the reducer onto the turbo inlet.
Synthamax Air Filters do not require oil. Service air
filter as needed by cleaning with common non-
petroleum all-purpose household cleaner and water.
Simple Green®, Formula 409® or equivalent works
great. Apply cleaner to outside of air filter and allow
to soak. Then flush filter clean from the inside out
with a garden hose and repeat steps if necessary. Do
not apply high pressure water or air to clean filter.
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!
16. Insert the large end of the Intake Tube into the
Hump Hose and tighten all 4 Intake Clamps at this time.
17. Reconnect the PCV and bypass line to the Airaid
Intake Tube.
18. Install the Airaid Premium Filter onto the Filter
Adapter inside of the Airbox.
19. Remove the protective film from the Lid and Win-
dow before installation. Install the Airbox lid and Win-
dow onto the Airbox, with the Window on top, using 6
sets of 1/4” Button Heads and Washers.
20. Reconnect the air temp sensor and plug the wire har-
ness anchor into the Airbox.
10. Replace the OEM O ring on the sensor with the sup-
plied Airaid O ring.
New
OLD
Lock Tab
Bolt
Pin
21. Double check your work. Make sure all clamps,
hoses, bolts, and screws are tight. Double check the hood
clearance. Reconnect the negative battery cable and rein-
stall the cover.
REV.04.14.15