Filter identification – Airaid 450-245 User Manual
Page 2
10. Reposition the plastic cover and then reinstall the
three plastic trim anchors removed in step #6 into their
respective holes and push down the center to secure the
plastic trim panel.
11. A.) Install the hump hose (#4) onto the filter
adapter as shown using two #72 hose clamps (#13).
Leave the clamps loose for now. B.) Install the supplied
reducing coupler onto the throttlebody as shown using
one #48 hose clamp (#11), and one #52 hose clamp
(#12). Tighten only the hose clamp on the throttlebody
at this time.
12. A.) Install the MAF sensor r emoved in step #5,
into the Airaid Intake Tube (#2). Use the two supplied 8-
32 button head bolts (#10), to securely fasten the MAF
sensor. Do Not Use The Factory Screws!
B.) Install the pr ovided gr ommet (#16) into the in-
take tube and then install the factory fitting removed in
step #5 into the grommet as shown.
13. Install the intake tube assembly into the hump hose
first, and then into the throttlebody coupler. Adjust for
fit, and then tighten the three remaining hose clamps.
Next, reconnect the MAF sensor wiring harness and lock
the red tab. Now reconnect the factory breather tube to
the factory fitting.
14. Install the Airaid Premium Filter (#1) onto the filter
adapter as shown and tighten the clamp. Now install the
supplied weather strip (#7) onto the top of the CAD as
shown starting near the radiator and working towards
the left fender.
15. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses, bolts,
and screws are tight. Double check the hood
clearance.
Reconnect the negative battery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.10.25.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
A.
B.
A.
B.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is
reusable and should be cleaned periodically.
FILTER IDENTIFICATION
700-466 Airaid Oiled Media 701-466 Airaid SynthaMax Dry Media - Red
702-466 Airaid SynthaMax Dry Media - Black 703-466 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.