Airaid 450-174 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
13. Install the Airaid Intake tube onto the throttlebody
first then into the Hump Hose and tighten the clamps.
Reconnect the crank case breather line to the Aluminum
fitting on the Intake Tube.
10. Remove the factory upper air box mounting grom-
met and steel sleeve, and re-install into the Airaid CAB.
11. Install the hump hose (#5) and two #72 hose clamps
(#12) onto the filter adapter as shown. Leave the two hose
clamps loose for now.
12. Install the CAB into the vehicle. Make sure that the
air inlet of the CAB aligns with the factory duct, and
the two locating pins on the bottom are seated in the
factory grommets. Next reinstall the factory bolt that
was removed in step #3 thru the steel sleeve and grom-
met and into the inner fender.
17
. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses, bolts,
and screws are tight. Double check the hood
clearance!
Reconnect the negative battery cable!
REV.12.6.13
14. Install the Weather Strip (#8) onto the Cool Air Box
with the contoured edge rolling away from the filter area.
Start at the front of the vehicle and work your way back
15. Install the Airaid Premium Filter (#1) onto the filter
adapter and tighten the hose clamp.
16. Reconnect the Mass Air Flow sensor, which is now
located in the lower back side of the intake. Slide the
locking tab back into the connector.
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.
FILTER IDENTIFICATION
700-461 Airaid Oiled Media 701-461 Airaid SynthaMax Dry Media - Red
702-461 Airaid SynthaMax Dry Media - Black 703-461 Airaid SynthaMax Dry Media - Blue