Airaid 400-260 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.01.31.14
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is
reusable and should be cleaned periodically.
13. Connect the Wire Harness Extension to the air tem-
perature sensor.
10. Transfer the factory Air Temperature Sensor into the
Airaid Intake tube and align the sensor tab with the
Groove in the tube. Secure the sensor to the tube using
the 8-32 Button Head Bolt and the 3/4” washer.
11. Place the Airaid Intake assembly in the original loca-
tion of the Factory Air box and secure using the factory
hardware from step 4. Slide the coupler and clamps onto
90 deg. Elbow pipe and tighten the clamps.
12. Slide the coupler and clamps onto 90 deg. Elbow pipe
and tighten the clamps.
FILTER IDENTIFICATION
720-479 Airaid Oiled Media 721-479 Airaid SynthaMax Dry Media - Red
722-479 Airaid SynthaMax Dry Media - Black 723-479 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.
14. Plug the Harness Extension into the factory wire har-
ness and secure it using the supplied Zip Tie. Trim the
excess length
15. Install the Airaid Premium filter onto the Filter
Adapter and tighten the clamp. Install the weather strip
onto the top of the Air box as shown, with the contour
rolling away from the filter.
Make sure there is no foreign material in the intake path.
Make sure all clamps, hoses, bolts, and screws are tight.
Double check the hood clearance!
Reconnect the negative battery cable!