Airaid 400-166 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
16. Install the Airaid Premium Filter inside the cold air
dam.
10. Mount the Airaid Cool Air Dam assembly to the
vehicle using the supplied metric bolts and washers. The
bolt on the right goes into the factory threaded hole. The
two bolts on the left go thru the CAD, the grommets,
and then the supplied bracket, with the nuts on the bot-
tom. (Note: The mounting bracket must be on the bot-
tom of the grommets.)
11. Install the urethane hump hose and two #72 hose
clamps. (Leave loose until final adjustments are
made.)
12. Install the two Airaid intake tube brackets on the
top of the intake manifold, using the four alumi-
num spacers on top of the bracket and the four
tower bolts. (Leave loose until final adjustments
are made.)
REV.10.23.13
17. Install the weather strip on top of the cool air dam.
(Hint: Start at one end and work towards the other
for an easier fit.) Spread the two hose mounts over
the radiator overflow hose, and insert one in each
hole at the ends of the cool air dam.
18. Check for foreign materials in the
intake, recheck your work. Check
nuts, bolts, and clamps for tight-
ness. Reconnect the negative bat-
tery cable
.
FILTER IDENTIFICATION
700-469 Airaid Oiled Media 701-469 Airaid SynthaMax Dry Media - Red
702-469 Airaid SynthaMax Dry Media - Black 703-469 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning with
common non-petroleum all-purpose house-
hold cleaner and water. Simple Green®,
Formula 409® or equivalent works great.
Apply cleaner to outside of air filter and
allow to soak. Then flush filter clean from
the inside out with a garden hose and re-
peat steps if necessary. Do not apply high
pressure water or air to clean filter. Allow
filter to air dry and reinstall.
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!
13. Install the Airaid intake tube over the throttle body,
and into the hump hose. A.) Install the two ¼-20
Allen bolts and washers thru the brackets and into
the tube. Push down on the throttle body end, and
lift up on the curve of the tube. Make sure the tube
is seated all the way down on the throttle body!
Tighten the Allen bolts, and then the tower bolts.
14. Install a ¼-20 Allen bolt and flat washer thru the
bracket at the back of the tube, and tighten. Tighten
the nut at the bottom of the bracket. Tighten the
hose clamps on the hump hose.
15. Reconnect the Mass Airflow Sensor and vacuum
hose. Reconnect the breather line, and vacuum
line in the clip. Reinstall the wire harness, and
heater control valve on the tower bolts.
A