Filter identification – Airaid 400-101 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
14. Install the Airaid Premium Filter onto the Sensor
Tube and tighten the clamp.
10. Mount the Sensor Tube onto the Panel Assembly
and secure using the two 1/4-20 Button Head Screws
and 1/4” Flat Washers.
12. Install the Tube and Panel assembly onto the Airaid
Intake Tube first, then insert the Panel tabs into the facto-
ry air box slots. Adjust the assembly until the OEM air
box clips can positively engage the Panels and lock.
13. Tighten the Clamps on the Hump Hose, reconnect
the MAF or MAP sensor and install the Weather Strip
as shown, with the contour rolling away from the Filter
area.
REV.09.16.14
15. Double check your work.
Make sure there is no foreign material in the intake path.
Make sure all clamps, hoses, bolts, and screws are tight.
Double check the hood clearance.
Reconnect the negative battery cable.
11. Slide the Hump Hose and Clamps onto the Sensor
Tube a shown.
FILTER IDENTIFICATION
720-478 Airaid Oiled Media 721-478Airaid SynthaMax Dry Media - Red
722-478 Airaid SynthaMax Dry Media - Black 723-478 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning with
common non-petroleum all-purpose house-
hold cleaner and water. Simple Green®,
Formula 409® or equivalent works great.
Apply cleaner to outside of air filter and
allow to soak. Then flush filter clean from
the inside out with a garden hose and re-
peat steps if necessary. Do not apply high
pressure water or air to clean filter. Allow
filter to air dry and reinstall.
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!
#68
Clamp
#56
Clamp
Tabs
Clips