Airaid 400-114 - Manual

Installation Instructions
For Part Numbers:
400-114 700-445 Airaid Oiled Media Filter
401-114 701-445 SynthaMax Dry Media Filter - Red
402-114 702-445 SynthaMax Dry Media Filter - Black
403-114 703-445 SynthaMax Dry Media Filter - Blue
1999- June 04 Ford F-250/F-350 Super Duty
Pickup 5.4L V8, 6.8L V10
2000- June 04 Ford Excursion 5.4L V8, 6.8L V10
*Does not fit vehicles produced after June 2004
Component Identification
1. Filter 1
2. Rear Back Panel 1
3. Left Side Panel 1
4. Filter Adapter 1
5. Hardware Pack 1
6. Weather Strip 1
7. Bushing 3
8. Gasket 4.5” 1
9. ¼”x20x7/8” Bolts 3
10. ¼”x20 Nuts 3
11. ¼” Washers 6
12. 32x5/16” Screw 6
13. 6/32 Nuts 6
14. #6 Washer 6
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number,
and click View Details.
I DISCONNECT NEGATIVE (-) BATTERY CABLE.
II Remove air filter.
a) Loosen clamp and separate. Remove filter.
b) Remove the FRONT half of air box, simply “pull up” to release. No tools needed. See Fig#2
c) These parts are not reinstalled in Airaid kit.
d) CAUTION: Do Not remove the REAR half of the air box or the “V”-BAND CLAMP.
III Remove air cleaner bracket.
a) Unbolt the 4 retaining bolts (10mm), and remove the bracket (See Fig#2) from the engine compartment.
b) Save the 4 bolts to reuse later. The bracket is not reused.
IV Assemble Airaid Cool Air Dam.
a) Bolt the two panels together with the supplied #6 hardware. See Fig#1
b) Bolt the Filter Adapter to the Back Panel with the supplied 1/4” hardware.
V Install in vehicle.
a) Set in place of the removed bracket.
b) Use the 4 saved 10mm bolts to fasten the Airaid assembly into the existing bracket mounting holes.
VI Connect to Airaid.
a) Slip supplied Rubber Gasket onto the 4.5” stub on the end of the Airaid assembly. This gasket will make
a seal between the Airaid and the stock rear half once connected. Be sure gasket is in place.
b) Slide stock rear half toward the Airaid and secure with the factory “V”-BAND CLAMP.
c) Press weather seal on to top edge of air box.
VII Finishing up
a) Check that no foreign objects are in the intake path.
b) Check throttle linkage for full open and closed travel.
c) Reconnect battery terminal. Enjoy!