Filter identification – Airaid 350-317 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
13. Secure the PCV Hose on both ends using the two
Speed Clamps.
10. Set the Well Nut into the hole in the inner fender.
11. Lower the Air Box assembly down into the inner
fender. Align the bolt holes and secure the Air Box using
the screw removed in step 3 and the 3/8” Button Head
Screw with the 5/16” Flat Washer.
12. Slide the factory intake tube onto the Airaid Tube,
adjust if necessary and tighten the Clamps. Connect the
crank case breather line to the Barbed filling using the
supplied PCV Hose.
REV.01.13.15
14. Install the Airaid Premium Filter onto the Filter
Adapter.
15. Install the Weatherstrip onto the top edge of the Air
Box with the contour rolling away from the Filter.
FILTER IDENTIFICATION
720-127 Airaid Oiled Media 721-127 Airaid SynthaMax Dry Media - Red
722-127 Airaid SynthaMax Dry Media - Black 723-127 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not re-
quire oil. Service air filter as
needed by cleaning with com-
mon non-petroleum all-purpose
household cleaner and water.
Simple Green®, Formula 409®
or equivalent works great. Ap-
ply cleaner to outside of air filter
and allow to soak. Then flush
filter clean from the inside out
with a garden hose and repeat
steps if necessary. Do not apply
high pressure water or air to
clean filter. Allow filter to air
dry and reinstall.
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!
Double check your work!
Make sure there is no foreign material in the intake path. Make sure all clamps, hoses, bolts, and screws are tight. Double check the hood clearance!
Reconnect the negative battery cable!