Filter identification – Airaid 310-208 User Manual
Page 2
19. Double check your work!
Make sure there is no foreign material in the intake path. Make sure all clamps, hoses,
bolts, and screws are tight. Periodically check all clamps, and fasteners for tightness.
20. Reconnect the negative battery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.11.7.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is
reusable and should be cleaned periodically.
13. Using one 1/4” button head bolt (#7), 1/4”
flat washer (#8), and 1/4” serrated nut (#9),
attach the CAD panel to the L-bracket, as
shown. Now tighten the radiator mounting
bolt on the other end of the L-bracket.
14. Install the supplied grommet (#17) into the
Airaid Intake Tube (#2).
15. Install the reducing hump hose (#5) onto
the throttle body as shown, with the #44 hose
clamp (#15) on the back, and the #52 hose
clamp (#16) on the front. Leave the clamps
loose for now.
16. Install the Airaid Intake Tube into the
hump hose first, and then rotate it down, and
into the CAD. Install two 1/4” button head
bolts (#7), and 1/4” flat washers (#8) thru the
CAD, and into the inser ts in the tube. Adjust
for fit, and tighten both hose clamps, and bolts.
17. Very Carefully r einstall the temper atur e
sensor removed in step #1, into the grommet in the
Airaid Intake Tube. Reconnect the factory breather
hose to the nipple on the intake tube.
18. Install the Airaid Premium Filter (#1) onto
the intake tube, and tighten the clamp. Next
install the weatherstrip (#6) onto the top of the
CAD as shown.
#44
#52
FILTER IDENTIFICATION
700-471 Airaid Oiled Media 701-471 Airaid SynthaMax Dry Media - Red
702-471 Airaid SynthaMax Dry Media - Black 703-471 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not re-
quire oil. Service air filter as need-
ed by cleaning with common non-
petroleum all-purpose household
cleaner and water. Simple Green®,
Formula 409® or equivalent works
great. Apply cleaner to outside of
air filter and allow to soak. Then
flush filter clean from the inside out
with a garden hose and repeat steps
if necessary. Do not apply high
pressure water or air to clean filter.
Allow filter to air dry and reinstall.