Airaid 310-176 User Manual
Page 2
19. Double check your work!
Make sure there is no foreign material in the intake path. Make
sure all clamps, hoses, bolts, and screws are tight. Periodically
check all hose clamps for tightness.
20. Reconnect the negative battery
cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.11.19.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
13. Remove the factory hose from step 2,
and install the new 3/8”x4” hose (#23) on the
end of the vacuum line as shown. Re-install
the vacuum line. (Refer to step 2.)
14. Install the ¼” barbed fitting (#22) into the
intake tube.
15. Install the urethane hump hose (#6) on
the CAD with two #60 hose clamps (#18),
and the coupler (#7) on the throttle body with
two #44 hose clamps (#17). Leave the
clamps loose for now.
16. Slide intake tube into the hump hose first,
and then into the coupler. Adjust for a good fit,
and tighten the hose clamps. Slide the vacuum
hose on the barbed fitting, and install one #16
speed clamp (#21) as shown.
17. Replace the factory breather hose with the
½”x 14” breather hose (#8) between the valve cov-
er and the intake tube using two #16 speed clamps
(#21) as shown.
18. Install the Airaid Premium Filter (#1)
and the weather strip (#9) onto the CAD, as
shown. (Hint: start the weather strip near the
radiator support and work towards the back
of the vehicle.)
FILTER IDENTIFICATION
700-452 Airaid Oiled Media 701-452 Airaid SynthaMax Dry Media - Red
702-452 Airaid SynthaMax Dry Media - Black 703-452 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.