Airaid 300-220 User Manual
Page 2
16. Double check your work!
Make sure there is no foreign material in
the intake path. Make sure all clamps,
hoses, fasteners, and wiring connections
are tight.
17. Reconnect the negative bat-
tery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.11.5.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST week-
days for questions regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air
filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WA-
TER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned periodically.
13. 2003 Models: Reconnect the factor y br eath-
er hose using the 1/2” x 5/8” connector (#21) and
1/2” x 4 1/2” breather hose. Secure the ends with
the #16 speed clamps (#17), and the #22 speed
clamps (#18) as shown.
14. Install the Airaid Premium Filter (#1) onto the
tube on the filter adapter and tighten the clamp.
Next install the weather strip (#7) on the top of the
Quick Fit Panel as shown. (Hint: Start at one end
of the CAD and work your way towards the other
end.)
10. Install the supplied reducing coupler (#4), onto
the throttle body using one #52 hose clamp (#10)
on the throttlebody and one #56 hose clamp (#11)
on the open end. Install the hump hose (#5) with
two #60 hose clamps (#12) onto the CAD.
11. Install the supplied grommet (#13) into the
Airaid intake tube(#2). Next, carefully install the
factory air intake temperature sensor into the
grommet in the tube. Make sure it is fully seated
into the grommet.
12. Install the Airaid intake tube into the hump
hose first, and then into the reducing coupler. Ad-
just for fit, and then tighten all four hose clamps.
2004-08 Models: Reconnect the br eather by
sliding the 3/4” x 2” hose (#24) over the factory
breather tube. Next insert the 1/2” to 3/4” barbed
connector (#20) into the 3/4” hose. Now connect
the 1/2” rubber elbow (#15) between the 1/2”
barbed fitting on the CAD and the previous fitting.
Now slide the rubber cap (#14) over the nipple on
the Airaid intake tube and secure it with the #14
speed clamp (#16).
FILTER IDENTIFICATION
720-472 Airaid Oiled Media 721-472 Airaid SynthaMax Dry Media - Red
722-472 Airaid SynthaMax Dry Media - Black 723-472 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not re-
quire oil. Service air filter as need-
ed by cleaning with common non-
petroleum all-purpose household
cleaner and water. Simple Green®,
Formula 409® or equivalent works
great. Apply cleaner to outside of
air filter and allow to soak. Then
flush filter clean from the inside out
with a garden hose and repeat steps
if necessary. Do not apply high
pressure water or air to clean filter.
Allow filter to air dry and reinstall.