A. b. a. b – Airaid 300-175 User Manual
Page 2
16. Double check your work!
Make sure there is no foreign material in the intake path. Make sure all clamps, hoses, bolts, and screws are tight.
17. Reconnect the negative battery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.11.4.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
13. Reconnect the AIT sensor wiring harness to
the sensor.
15. Install the Airaid Premium Filter (#1) onto
the Quick Fit Panel as shown, and tighten the
clamp.
10. Carefully install the AIT sensor into the
grommet in the Airaid Intake Tube. Make sure it
goes all the way in.
12. A.) Slide the Airaid Intake Tube into the
hump hose first.
B.) Slide the other end of the Airaid intake tube
into the reducing coupler on the throttle body.
Adjust the tube for fit, and tighten the clamps.
14. Install the weather strip (#6) onto the top of
the Quick Fit Panel as shown. (Hint: Start at one
end and work towards the other.)
11. A.) Install the urethane hump hose (#5) and
two #60 hose clamps (#9) onto the Quick fit
Panel.
B.) Install the reducing coupler (#4) onto the
throttle body using one #52 hose clamp (#8) on
the tube side, and one #48 hose clamp (#7) on
the throttle body side. (Leave the clamps loose
for now.)
A.
B.
A.
B.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST week-
days for questions regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air
filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WA-
TER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter is reusable and should be cleaned periodically.
FILTER IDENTIFICATION
720-440 Airaid Oiled Media 721-440 Airaid SynthaMax Dry Media - Red
722-440 Airaid SynthaMax Dry Media - Black 723-440 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not re-
quire oil. Service air filter as need-
ed by cleaning with common non-
petroleum all-purpose household
cleaner and water. Simple Green®,
Formula 409® or equivalent works
great. Apply cleaner to outside of
air filter and allow to soak. Then
flush filter clean from the inside out
with a garden hose and repeat steps
if necessary. Do not apply high
pressure water or air to clean filter.
Allow filter to air dry and reinstall.