Filter identification – Airaid 300-157 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
13. Slide the hump hose on to the straight end of
Airaid intake tube with two #60 hose clamps.
(Note: Leave hose clamps loose until final assem-
bly).
10. Install the Airaid Quick Fit assembly on top of
the factory air filter base. Relatch the clips,
and tighten the hose clamp.
11. Using the supplied pre-formed 3/4” breather
hose, connect the nylon fitting to the remaining
plastic factory hose as shown. Fasten both ends
of the hose using the supplied nylon speed
clamps. Adjust the fitting downward to clear
the factory intake tube assembly.
12. Install the supplied reducing coupler and #52
hose clamp onto the throttle body. Install the
#56 hose clamp on the opposite end.
REV.11.4.13
14. Install the Airaid intake tube assembly by con-
necting the Airaid hump hose onto the air filter
adapter, and the other end into the Airaid re-
ducing coupler. Tighten all hose clamps.
15. Install the supplied rubber grommet and fac-
tory air temperature sensor into the Airaid
intake tube. Next, reconnect the factory elec-
trical connector onto the sensor.
FILTER IDENTIFICATION
700-450 Airaid Oiled Media 701-450 Airaid SynthaMax Dry Media - Red
702-450 Airaid SynthaMax Dry Media - Black 703-450 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning with
common non-petroleum all-purpose house-
hold cleaner and water. Simple Green®,
Formula 409® or equivalent works great.
Apply cleaner to outside of air filter and
allow to soak. Then flush filter clean from
the inside out with a garden hose and re-
peat steps if necessary. Do not apply high
pressure water or air to clean filter. Allow
filter to air dry and reinstall.
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!
16. Install the Airaid Premium Filter on the end of
the air filter adapter. Install the supplied
weather strip on the Quick Fit panel. (Note:
start from one end and work your way around
to insure proper alignment of weather strip.)
17. Double check your work to be certain that all
nuts, bolts, and clamps are securely fastened.
18. Reconnect the negative battery cable.
Hump Hose