Filter identification, Provision for some ‘03 and ‘ 04 models – Airaid 300-151 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM -
5:00 PM MST weekdays for questions regarding fit or instructions that are not clear to you. Your Airaid
Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged
during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct ex-
posure to water and debris; care should be taken not to drive through deep water. WATER INGESTION IS
THE DRIVERS RESPONSIBILITY! The air filter is reusable and should be cleaned periodically.
REV.11.1.13
FILTER IDENTIFICATION
720-440 Airaid Oiled Media 721-440 Airaid SynthaMax Dry Media - Red
722-440 Airaid SynthaMax Dry Media - Black 723-440 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall.
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!
13. Factory coupler must be orientat-
ed with the clamp screw at the 12
o’clock position.
14. If your vehicle is equipped
with an air temperature sensor,
insert the rubber grommet into the
hole on the intake tube and mount
the air temperature sensor into the
grommet.
15. If your vehicle is not equipped
with an air temperature sensor, in-
sert the rubber grommet plug into
the hole on the intake tube.
16. Reconnect the crankcase
breather hose to the tube on the
Airaid Cool Air Dam and secure
with the black speed clamp provid-
ed. (Note for 2004: Replace breath-
er hose with new ½” ID hose and
speed clamps provided.)
17. If your vehicle is equipped with a
dipstick tube that interferes with the
location of the Airaid Intake System,
an adjustment to the dipstick tube
must be made. Firmly grasp the dip-
stick tube about 6 inches below the
top with your left hand and carefully
form the tube towards the engine.
This will allow for clearance of the
Airaid Intake System.
18. Double check your work to be certain
that all nuts, bolts, and clamps are secure-
ly fastened.
19. Reconnect the negative battery cable.
Provision for Some ‘03
and ‘ 04 Models