Airaid 300-125-1 User Manual
Page 2
8. Double check your work!
Make sure there is no foreign material in the intake path.
Make sure all clamps and hoses are tight.
9. Re-connect the negative battery cable!
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.10.31.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST week-
days for questions regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air
filter element is protected from direct exposure to water and debris; care should be taken not to drive through deep water. WA-
TER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is reusable and should be cleaned periodically.
5. 2002-2003 Models Only: Slip the black rubber cap (#6)
over the nipple on the CAD and secure it using one #19
speed clamp (#5).
6. 2004-2005 Models Only: Reconnect the factory breather
hose to the nipple on the CAD and secure it using one #24
speed clamp (#4).
7. Mount the Airaid Premium Filter (#1) onto the CAD and
tighten the hose clamp. Install the weather strip (#3) onto the
top of the CAD as shown. (Note: start at one end and work
your way around to the other to insure proper alignment of
the weather strip).
FILTER IDENTIFICATION
700-445 Airaid Oiled Media 701-445 Airaid SynthaMax Dry Media - Red
702-445 Airaid SynthaMax Dry Media - Black 703-445 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.