Filter identification – Airaid 250-315 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
13. Check the positioning of the Mass Air Flow meter in
relation to the wire harness. Readjust if necessary and
tighten the clamps. Reconnect the Air Flow meter.
10. Transfer the factory air box scoop into the Air Dam
assembly as shown. When properly installed, a distinct
snap will sound indicating that it has locked firmly in
place.
11. Install the Air Dam assembly into the inner fender
area of the vehicle in the same manner as the OEM air-
box. The grommets and sleeves are to be secured to the
inner fender by re using the 6mm nuts that were removed
in step Three.
12. The bottom of the Air Dam assembly is to be se-
cured using the grommet and post. Re connect the in-
take tube to the Mass Air Flow meter and reinstall the
battery post cover.
REV.1.30.14
14. Install the Airaid Premium Filter on to the Filter
Adapter.
15. Install the Weatherstrip onto the top edge of the Air
Dam with the contour rolling away from the Filter.
FILTER IDENTIFICATION
700-469 Airaid Oiled Media 701-469 Airaid SynthaMax Dry Media - Red
702-469 Airaid SynthaMax Dry Media - Black 703-469 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not re-
quire oil. Service air filter as need-
ed by cleaning with common non-
petroleum all-purpose household
cleaner and water. Simple
Green®, Formula 409® or equiva-
lent works great. Apply cleaner to
outside of air filter and allow to
soak. Then flush filter clean from
the inside out with a garden hose
and repeat steps if necessary. Do
not apply high pressure water or
air to clean filter. Allow filter to
air dry and reinstall.
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!
Grommets and Sleeves
Grommet and Post
Double check your work!
Make sure there is no foreign material in the intake path. Make sure all clamps, hoses, bolts, and screws are tight. Double check the hood clearance!
Reconnect the negative battery cable!